How to Change the Rubber Gaskets for a Vertical Sliding Window

The rubber washers at the top and bottom of the window frame deteriorate over time.Worn-Out gaskets allows air to enter or leave your home, which increases the energy needed to heat and cool your home.Replacing the rubber gasket will seal the window and eliminate the problems caused by the ventilated window.If you are replacing the rubber gasket on the vertical sliding window, make sure to check the caulking around the window glass and frame and replace it if required.Grab the old rubber gasket at the top of the window frame, pull it up and remove it.Open the window, pull the rubber gasket on the track up and remove it.Clean the track with cloth and everythingThe purpose is cleaner.Close the window and clean the top of the belt with cloth and everythingThe purpose is cleaner.Measure the length of the top of the belt with a tape measure.Cut a piece of rubber gasket into this length with scissors.Push the rubber gasket into the top of the belt with your finger.Open the window and measure the length of the track.Cut a piece of rubber gasket into this length.Place the new rubber gasket on the track and press it down with your fingers.Close the window.Open and close the window several times to ensure that the new rubber gasket does not interfere with its operation.